Just a short update on the Fire Raptor today. I have taken the time to straighten the resin pieces that were warped. As you can see from the first photo below, some of the parts can be fairly out of shape. It's inevitable with resin, but easily fixed. I use the hot water method but a hair dryer or a heat gun can be used (but use a heat gun with extreme care as they get far hotter than a hair dryer and can melt resin and skin with ease). As with all of these dangerous maneuvers, if you are a child, please get an adult to help you. No burns please. On we go.
So with the hot water method, what I do is use a shallow dish of some description and add boiling water with some cold added. At a guess, I'd say it was around 60 degrees centigrade, but I've never measured it. It's definitely way below boiling (how dangerous would that be?). Add the offending part to the water and make sure you have something you can retrieve it with that isn't your own digits. You only really need to leave most pieces in the water for about 15-30 seconds. Thicker parts may need a little while longer to warm up. Remove it from the water and very gently test it to see if it's flexible. Don't force it as you can snap it and I won't be held responsible.
When it's pliant enough, carefully bend it back in to the shape it should be. Some pieces will naturally start to straighten when they've been heated, Once you are happy, you can either use some cool water or just hold the part until it's cooled. Hey presto, you should have a resin part that's back to how it should be.
You can see below that I have done a dry fit of the main fuselage to make sure it will glue correctly. It's only held together with weak elastic bands so I'm pretty confident it will glue quite well.
Next up is the cleaning (even though I said that was next last time)
No comments:
Post a Comment